642-176 - SMBE - SMB Engineer
Go back to
Cisco
Example Questions
When determining a customer's technical requirements for a Cisco Unified Communications solution, which important tool can be used to determine the bandwidth used by different codecs with various voice protocols over different media?
Voice Codec Bandwidth Calculator
Your customer has 21 users, each requiring both PC and IP phone connectivity. Which is the correct configuration for this customer?
1 Cisco 2801 ISR, 1 Catalyst Express 500-24PC
Which three of these are prerequisites for resetting a Catalyst Express 500 switch when Cisco Network Assistant is unavailable? (Choose three.)
physical access to the switch
at least one enabled switch port that is unconnected to any device
a PC or laptop with Windows 2000 or Windows XP installed and a web browser that has JavaScript enabled
Which statement correctly describes network security settings in Cisco Network Assistant for the Catalyst Express 500 switch?
The "LOW" setting enables broadcast storm control and limits the number of devices that can connect to a switch port.
To protect the network from external and internal threats, where should Cisco IPS be enabled on an ISR?
on the WAN and LAN interfaces of the ISR
When using Cisco Network Assistant to configure Smartports, which two of the following roles can belong only to a VLAN of the type "access"? (Choose two.)
phone + desktop
desktop
Which two statements about 802.1Q trunking in Secure Network Foundation Design Guide for Single Site Deployments are correct? (Choose two.)
802.1Q trunking is used between the access switch and the router.
The Cisco Control VLAN carries only layer 2 control traffic.
Which two WAN access methods are specified for a simplified and cost-effective Cisco Single-Site Secure Network Foundation deployment design? (Choose two.)
DSL
Cable
The recommended WAN access method for a simplified and cost-effective Cisco Single-Site Secure Network Foundation deployment provides which type of service?
best-effort
When determining a customer's security requirements using the security site survey from the Steps for Success methodology, which three of these should be included in the customer's security policy and procedures? (Choose three.)
third-party due diligence policy review
remote access policy
application change control policy
What is the reason for running spanning tree in a Cisco Single-Site Secure Network Foundation solution?
to protect the network in case someone inadvertently creates a physical loop in it
When using Cisco Network Assistant to configure a WS-CE500-24LC switch, which three are available choices in the port settings window? (Choose three.)
duplex mode selections
auto MDIX selections
status selections
Which WAN connection requires a different interface than the standard interfaces provided in the Cisco Single-Site Secure Network Foundation deployment design?
Frame Relay
When using the Steps to Success Methodology, where does Quote Builder fit into the deal process flow?
It encompasses the Validate and Solve steps.
Which routing method is used to determine the forwarding paths for IP traffic in a Secure Cisco Single-Site Secure Network Foundation solution with remote teleworkers?
static and default routes
When resetting a Catalyst Express switch to factory default settings, which three options are available from the Software Recovery window? (Choose three.)
erase the system configuration
boot with the factory default image
erase the system configuration and boot with the factory default IOS image
In an environment in which multiple VLANs have been defined on Catalyst Express 500 switches, which two statements are correct for ports that have been configured with the Smartport role of "IP Phone+Desktop"? (Choose two.)
The ports may belong to a configurable data VLAN.
The names of the VLANs used by the Smartports are case sensitive.
Which statement describes the remote sites in a Cisco Single-Site Secure Network Foundation solution with remote teleworkers?
They are in separate subnets but are part of the private address space of the network.
When enabling IPS on an ISR using the Cisco SDM IPS Wizard, in what location can the SDF be placed?
on the flash memory of the ISR