640-792 - Supporting Cisco TelePresence System Devices v1.0 (TPTECH)

Go back to Cisco

Example Questions

Which two hardware components are included with the Cisco TelePresence 1000? (Choose two) Which three of the following components are included on the Cisco TelePresence 3000 and 3010? (Choose three) Which two hardware components are optional on the Cisco TelePresence 500? (Choose two) After replacing the Primary Codec, which two of the following components require setting to be saved on the new Codec? (Choose two) How many eternal network connections are required for a Cisco TelePresence system? What IP phone information is needed to register with Cisco Unified Communications Manager? When a Windows PC is plugged into the Codec and receives the IP address from the Codec via DHCP, which Windows command can you use to find the CT5 Codec IP address? Which Cisco TelePresence system creates a category called Personal TelePresence? Which port do you use on you, laptop to establish a connect with the Secondary Camera port on the Primary Codec? What is the maximum number of microphones that you can have m a 3200/3210 room? OA Which size and type of tool is required to loosen the screws that allow rotational adjustment of the CTS-3010 cameras? Which port do you conned to on the Primary Codec in order to establish an Ethernet connection between your laptop and the Cisco TelePresence 3000 equipment? Which three hardware components are optional on the Cisco TelePresence 1100? (Choose three) Which Cisco Telepresence System does not have an external microphone? For the CTS-3200 and 3210, how far should the top of the large target be placed from the top of the small target when conducting final focus on the camera? Which command will tell you if there are any peripherals that are being upgraded on your CIS system using SSH? A Cisco TelePresence Codec is added in Cisco Unified Communications Manager as a(n); Which two hardware components are optional for the Cisco TelePresence 1000? (Choose two) Which command would you use to verify the CT5 system upgrade status using the SSH console? Which network settings do you configure for the Ethernet port on your laptop to gain access to the CTS system? Which three of the following tools are required for camera alignment? (Choose three) Which type of Ethernet cable do you use to connect from the Ethernet port on your laptop to the secondary camera port on the primary codec? Which two statements are true about the HFR Presentation Codec? (Choose two) What is the first step to reset a 7900 series IP phone to the factory default? Which three of the following components are included on the Cisco TelePresence 3210? (Choose three.) Which port is indicated on the right Secondary Codec for the CTS-3210? Which username and password should you use to perform a password recovery on the Primary Codec from the SSH console? The right camera on a CTS-1300 is showing a red X in system status. The error is an Ethernet error. Which cable should you check to verify connection from the right camera to the Codec? The Cisco TelePresence 1100 is designed to typically support how many meeting participants? Which command would you use from the SSH command line in order to check the level of firmware on your Auxiliary Control Unit? What size and type of tool, if any, is required to adjust the up/down tilt of the camera for the CTS- 3010? Which Cisco TelePresence System component controls the light shrouds on a Cisco TelePresence 3010 or 3210 system? Which transport layer protocol is used for real-time voice and video traffic? How many microphones can you directly connect to a Generation 2 Primary Codec (CTS-CODEC- PRI-G2)?