6103 - Avaya ERS 8000 and Avaya VSP 9000 Implementation Exam

Go back to Avaya

Example Questions

While troubleshooting the VSP 9000 system, a technician notices that one port Link/Activity LED is blinking constantly or is nearly solid. This could be an indication of mis-configuration or high traffic volume. Using the CLI, what is the logical first step in troubleshooting this situation? A port on the Virtual Services Platform (VSP) 9000 is down because of a link_flap condition as shown in the following output: VSP-9012:1#show interfaces gigabitEthernet state 10/8 ================================================================ Port State ================================================================ PORT NUM ADMINSTATUS PORTSTATE REASON DATE -------------------------------------------------------------------------------------------------- 10/8 up down LINK-FLAP 10/28/10 00:22:50 What is the most likely cause? When configuring an Ethernet Routing Switch (ERS) 8000 for Split Multi Link Trunking (SMLT), protection against an edge switch in the factory default condition must be taken into consideration. Which parameter will help prevent loops on the SMLT ports? Which two management ports are available on the VSP 9000 CP module? (Choose two.) Which file on the internal flash of Avaya Virtual Services Platform 9000 is used to specify the primary and backup release names? Using Enterprise Device Manager, the technician opens the ERS 8000 switch and sees that there are five ports showing with an orange light. What does the orange light indicate? Given the following command: VSP-9012:1S show khi performance Which Key Health Indicator is only valid for the CP modules? Which multicast technology, used with the Virtual Services Platform (VSP) 9000, allows the router to determine whether any group members exist on its directly connected networks and switches? A customer is concerned about the security of their network. They need to understand the OSPF authentication options when accepting route updates in OSPF. Currently, their Virtual Services Platform (VSP) 9000 is configured to require no authentication when receiving the OSPF updates. Which two supported authentication types would provide security on the VSP 9000 for OSPF updates? (Choose two.) After a chassis failure, you replace the Avaya Ethernet Routing Switch 8800/8600 with a new chassis that has a new base MAC address. To transfer the existing license to this new chassis you must have the new base MAC address. Which CLI command will show you the base MAC address of your new chassis? Which ACLI command is used to display SMLT port configuration? In the current business environment everyone is being asked to do more with fewer physical resources. Using virtualization allows the Virtual Services Platform (VSP) 9000 to increase the services provided. By using VRF-Lite, what does the VSP 9000 eliminate the need for? The VSP9000 uses three distinct traffic management profiles, configured with the boot config flag fabric-profile command. What is the default profile in the VSP9000? On an ERS 8000, which command is used to see the state of an installed interface card? A technician is implementing a new network that contains eight Ethernet Routing Switch (ERS) 8000 switches, and also uses advanced features. One of the eight switches will run Shortest Path Bridging. Which two licenses are needed in this situation? (Choose two.) A campus network requirement is to introduce Virtual Routing and Forwarding (VRF) in the existing Virtual Services Platform (VSP) 9000 core. The technician needs to configure VRF on the VSP 9000. Which statement represents the proper order for configuring a new VRF? After configuring your VSP 9000 for web access, engineers on the team says that they cannot log into EDM using their credentials. What are the default credentials for EDM? To confirm that RSMLT will work on a set of VLANs, which network design aspect should be considered? Where can someone find the upgrade prerequisites and new features for a particular software release? For maximum cooling, how many cooling modules does a Virtual Services Platform (VSP) 9000 chassis need? What will the boot flag ftpd do to your system on startup? A technician is configuring a Link Aggregation connection from a stack of Ethernet Routing Switch (ERS) 5500 switches, to a core pair of ERS 8000 switches. Which statement about the correct uplink configuration is true? When configuring a new Ethernet Routing Switch (ERS) 8000 using the default interface, the attempt to load an ACLI configuration fails because the default interface is the CLI. How is the ACLI interface obtained? Given the following error message: Power Supply Down(PsID=1,OperStatus=4) What does the error message mean regarding the power supply? A customer has a edge switch connected to a cluster of VSP 9000 switches. The uplinks to the network core are via two Gigabit uplink ports. The uplinks are not aggregated and are running spanning tree protocol. The result is that one of the links is always being blocked, and recovery time is unacceptably long when the active uplink fails. They need to have both links active to increase the bandwidth to the core, and at the same time provide better redundancy. What is the preferred Avaya solution for the customer? Flight Recorder can be used on the Virtual Services Platform (VSP) 9000 to help Identify problems. When can a Flight Recorder snapshot be taken? Source MAC address-based VLANs are an example of which group of VLAN types? On an ERS 8000 system that is configured for use with IPv6, which command would show whether or not the VRRP instance is configured correctly on a particular interface? A technician has installed the Advanced License. After initial configuration of an ERS 8000 system, the technician must also configure VRF for use on the network. Which license enables the use of VRF? On the VSP 9000 and ERS 8000, the Switch Fabric (SF) modules are installed to intelligently switch or route traffic coming into the chassis. What determines the SF module function on the VSP 9000? Both the VSP 9000 and ERS 8000 systems support Custom Auto-Negotiation Advertisements (CANA). These advertisement messages are used by both ends of a link. What information do these messages determine? Which CLI command is used to validate that synchronization for High Availability mode is correct? After issuing a show mlt ist stats (CLI) or show ist stat (ACLI) command, it is determined that the running type is normal MLT and not IST. What are two causes of the IST not running properly? (Choose two.) Within an STP enabled ERS 8000 switch, what will the vlan create <vid> name <vlan name> type port <instance_id> command create? During a power-on or cold-start sequence, at which stage can the flags to change the operational environment of the switch be set? Which statement describes a characteristic of Routed Split Multilink Trunking (RSMLT) configuration? Once created, which ACLI command line syntax is used to see that an instance of VRF is configured correctly? The attempt to manage an Ethernet Routing Switch (ERS) 8000 using a VRRP address was unsuccessful. What is causing this problem? Which function does the "RS" module for the ERS 8000 provide that the "R" module does not? A customer is mirroring multiple ports to a single monitor port. What happens if the mirrored traffic exceeds the bandwidth of the monitor port? Policy-based traffic policers and traffic shapers identify traffic using a policy (a contract). Traffic that conforms to this policy (a service contract) is guaranteed transmission, and nonconforming traffic is considered in violation. Which two statements about how Policy-based policers and shapers treat violations are true? (Choose two.) How do the Switch Fabric (SF) modules provide bandwidth management across the I/O modules? Which statement describes how to configure Simple Loop Prevention protocol (SLPP) Rx? In a VSP 9000 chassis, which command is used to see the information on the installed software? On the VSP 9000, there are a maximum of 256 VRRP instances per VRF. What is the maximum number of instances that are allowed on the system? An engineer is configuring the VSP 9000 for EDM management, and cannot connect from the EDM computer to the VSP 9000. Once logged into the ACLI, which show command is used to see the status of the web server? A company has a virtualized computing environment, and their VSP 9000 can be configured so that the ports are considered "lossless" in their redundant network design. Which two traffic types are supported on a "lossless" port? (Choose two.) Avaya Command Line Interface (ACLI) is an industry standard CLI that can be used to manage the Virtual Services Platform (VSP) 9000. From within which CLI context would you enable global routing settings? Given the following syntax: config ethernet <ports> ip create <ipaddr/mask> <vid> [mac_offset <value>] Which action is depicted in the command above? The Key Health Indicators (KHI) feature of Avaya Virtual Services Platform 9000 provides a subset of health information that allows for quick assessment of the overall operational state of the device. The show khi forwarding commands are the way to view this health information. What kinds of slots are the show khi forwarding commands valid for?