200-101 - Interconnecting Cisco Networking Devices Part 2 (ICND2)

Go back to Cisco

Example Questions

What are two characteristics of Frame Relay point-to-point subinterfaces? (Choose two.) Which two options are valid WAN connectivity methods? (Choose two.) Ciscoルーター上でIPv6ルーティングをイネーブルにするコマンドはどれですか。 Which port state is introduced by Rapid-PVST? What is the advantage of using a multipoint interface instead of point-to-point subinterfaces when configuring a Frame Relay hub in a hub-and-spoke topology? What is one benefit of PVST+? Which of these represents an IPv6 link-local address? Which command allows you to verify the encapsulation type (CISCO or IETF) for a Frame Relay link? Which PPP subprotocol negotiates authentication options? Which parameter would you tune to affect the selection of a static route as a backup, when a dynamic protocol is also being used? What does a router do if it has no EIGRP feasible successor route to a destination network and the successor route to that destination network is in active status? Which two of these statements regarding RSTP are correct? (Choose two.) 認証オプションを交渉するPPPサブプロトコルはどれですか。 A network administrator needs to configure a serial link between the main office and a remote location. The router at the remote office is a non-Cisco router. How should the network administrator configure the serial interface of the main office router to make the connection? Which three of these statements regarding 802.1Q trunking are correct? (Choose three.) Which command enables IPv6 forwarding on a Cisco router? Which term describes a spanning-tree network that has all switch ports in either the blocking or fowarding state? Which protocol is an open standard protocol framework that is commonly used in VPNs, to provide secure end-to-end communications? An administrator is troubleshooting a problem between routers that are using different versions of RIP. Which two commands would provide information about which version of RIP was being sent and received on an interface? (Choose two.) What can be done to secure the virtual terminal interfaces on a router? (Choose two.) Which command is used to enable CHAP authentication, with PAP as the fallback method, on a serial interface? Which parameter or parameters are used to calculate OSPF cost in Cisco routers? ハブアンドスポーク接続でフレームリレーハブを設定する場合、ポイントツーポイントサブインターフェイスの代わりに マルチポイントインターフェイスを追加する利点は何ですか? In the Frame Relay network, which IP addresses would be assigned to the interfaces with point- to-point PVCs? At which layer of the OSI model does PPP perform? ダイナミックルーティングプロトコルのバックアップとして、スタティックルートが選択されるようにするパラメーターはどれですか。 What occurs on a Frame Relay network when the CIR is exceeded? Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers? EIGRPフィージブルサクセサの宛先ネットワークへのルートと、その宛先ネットワークの後継ルートが アクティブ状態になっているを持っていない場合、ルータは何をしますか? Which type of EIGRP route entry describes a feasible successor? What does the frame-relay interface-dlci command configure? What can be done to Frame Relay to resolve split-horizon issues?(Choose two.) The following configuration is applied to a Layer 2 Switch: interface fastethernet 0/4 switchport mode access switchport port-security switchport port-security mac-address 0000.1111.1111 switchport port-security maximum 2 swithcport port-security What is the result of the above configuration being applied to the switch? What is the default maximum number of equal-cost paths that can be placed into the routing table of a Cisco OSPF router? What are two drawbacks of implementing a link-state routing protocol? (Choose two.) What command visualizes the general NetFlow data on the command line? In GLBP, which router will respond to client ARP requests? The output of the show frame-relay pvc command shows "PVC STATUS = INACTIVE". What does this mean? OSPF リンク状態のコレクションの表示に使用するコマンドはどれですか? Which two statistics appear in show frame-relay map output? (Choose two.) RSTPがループの防止に使用するOSIモデルのレイヤーはどれですか。 What is the purpose of LCP? Rapid-PVSTで導入されたポートの状態はどれですか。 What command is used to verify the DLCI destination address in a Frame Relay static configuration? 部門は、ハブをもう一つの部門によってもはや必要でないCatalyst 2950switchと交換することに決めます。 インストールのためにswitchを準備するために、ネットワーク管理者は最初の構成を消してswitchをリロードしました。 しかし、switchに接続しているPCはいろいろな連結性問題を経験します。 問題の可能性がある原因は、何ですか? Which protocol provides a method of sharing VLAN configuration information between two Cisco switches? Which statements are true about EIGRP successor routes? (Choose two.) Which two statements describe the process identifier that is used in the command to configure OSPF on a router? (Choose two.) Router(config)# router ospf 1 What is a valid HSRP virtual MAC address? What are two enhancements that OSPFv3 supports over OSPFv2? (Choose two.)

Study Guides